check_temp_ha7net (Visit this link)

from 0 votes

Checks temperature using the Embedded Data Systems HA7Net 1Wire bridge



check_1wire-ha7net 0.1

2007-05-18  Eric Cronin 

PUBLIC DOMAIN



Checks temperature using the Embedded Data Systems HA7Net 1Wire bridge



Usage: check_1wire-ha7net [-h] [-F] -H hostname [-s] -D device_id -w  -c 

Required Arguments:

  -H     HA7Net hostname

  -D     64-bit 1Wire device ID (hex)

  -w     Generate warning state if temperature outside this range

  -c     Generate critical state if temperature outside this range

Optional Arguments:

  -h     This help message

  -F     Ranges are in Ferenheight instead of Celsius

  -s     Connect to HA7Net over HTTPS

Range Syntax:

  Ranges can be specified as min:max, max:min, min:, :max, or max

  For max:min, alert is generated if temperature is inside the range

Supported 1Wire devices:

  Dallas DS1820, DS18B20

  EDS HMP2001S

Submitted by: ecronin
Hits: 511
Overall downloads: 0
Added: 2007-05-19 00:00:00
Last Modified: 2008-03-31 00:00:00

Comments

Be the first to comment this project.

If you just want to rate the project leave the other field empty.
Even though it would be nice if you would drop a line.

check_snmp_temperature

3 from 1 votes

General temperature check plugin - supports dell, hp, cisco, juniper, alteon. Other types can be specified easily if you know temperature SNMP OIDs. Data can also be returned as performance values for graphing or other processing.
Check_disk_snmp

3 from 1 votes

Check Disk space via SNMP standard MIB query.
A Rittal CMC-TC Temperature Sensor Nagios Plugin

5 from 1 votes

Nagios Plugin that checks the temperature sensors of the Rittal CMC-TC monitoring system via SNMP. The plugin output language is German.
Speed fan

5 from 1 votes

Reads temperature, voltage or fanspeed from the speedfan service
check_akcp

2 from 1 votes

This plugin is checks sensors on AKCP devices.

TempTrax

5 from 1 votes

TempTrax is a seriell or Ethernet Device to monitor temperature.
HW group Plugins for Hwg-STE - Damocles - Poseidon

from 0 votes

check_hwg-ste: Nagios Plugin for HW group Hwg-STE - check_poseidon: Nagios Plugin for HW group Poseidon Series - check_damocles: Nagios Plugin for HW group Damocles Series
Nagios Plugin for Baytech PDU

from 0 votes

This is a nagios plugin that checks Baytech PDUs. It will report and alllow to set alerts on Current, Temperature, Power when you give it name of the PDU to be checked.
Knürr: check_knuerr_rms.pl

from 0 votes

This plugin could be used for monitoring your Knuerr RMS environmental monitor. It is also able to monitor the new Knuerr Di-View appliance with power clamps
check_snmp_acs_pm

from 0 votes

Poll an Avocent ACS via SNMP for information about connected iPDU units.